Digital OBD2 Průvodce řešením problémů stáhnout pdf

MAN #650387

STA-1000

Speed/Tach Interface Module for OBD-II vehicle interface

POWER

GROUND

OBDII

INPUT

CRUISE 4K OUTPUT

VSS INPUT FROM TRANS

TACH 2

TACH 1

SPEED 2

ENGINE

SPEED 1

www.dakotadigital.com

[email protected]

605-332-6513

STA-1000

OBDII INTERFACE

OBD-II

Connect to vehicle

diagnostic port

setup/status switch

Connect to main

chassis ground

+12V

KEY ON POWER

(fused 5 - 20 AMP max)

Standard 0-12V tachometer output.

High voltage tachometer output.

to engine lamp

keyed power

bulb

AC speedometer output.

Standard speedometer output.

Optional

cruise control

connections.

Cruise Control 4k ppm output.

Vehicle speed signal from transmission.

This unit has an input to read engine information from vehicles using the GM 1996-up OBD-II protocol, Ford 1996-up

OBD-II protocol, some Chrysler 2000-up OBD-II protocol, or CAN OBD-II protocol. CAN OBD-II is used on all vehicles

2008 and newer and some vehicles from 2004 – 2008. It provides speedometer, tachometer, and engine indicator

outputs. Do not mount this in the module in the engine compartment; it should be mounted in interior of the vehicle.

Operation

The RPM and speed can be provided by this unit instead of trying to find a compatible connection somewhere in the

vehicle wiring harness. These outputs can be calibrated to match the gauge being connected.

The malfunction indicator lamp (MIL) or service engine soon indicator will be activated from the data bus when there is

an engine code set. This will not turn on the indicator for a lamp test function when the key is on, but the engine is not

running.

Since a cruise control will typically not work well with the speed data from the diagnostic bus, a connection is provided

to connect a VSS signal directly from the transmission and then provide a calibrated 4000 ppm output. The output is

self calibrated by reading the incoming transmission VSS signal and comparing it with the speed data from the

diagnostic bus.

1 2 3 4

Shrnutí obsahu

Strany 1 - STA-1000

MAN #650387 STA-1000 Speed/Tach Interface Module for OBD-II vehicle interface POWERGROUNDOBDII INPUTCRUISE 4K OUTPUTVSS INPUT FROM TRANSTACH 2TACH

Strany 2 - MAN #650387

MAN #650387 Setup Menu -Id 61,62,F1,F2 set the J1850 device ID. CYL 4,6,8 set the engine cylinder count CAL 3.0 – 20.0 set the speedometer cal

Strany 3 - Troubleshooting guide

MAN #650387 Id Setup When using the pre-CAN bus GM J1850 or Ford J1850 protocols the unit must have a unique ID to identify itself on the bus. By def

Strany 4

MAN #650387 SERVICE AND REPAIR DAKOTA DIGITAL offers complete service and repair of its product line. In addition, technical consultation is availabl

Komentáře k této Příručce

Žádné komentáře

Digital OBD2 Průvodce řešením problémů

Procházejte online nebo si stáhněte Průvodce řešením problémů pro ne Digital OBD2. Digital OBD2 Troubleshooting guide Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro ne Digital OBD2