Digital LA400 Servisní příručka stáhnout pdf (Strana 76)

Maintenance Manual Removal and Replacement

____________________________________________________________________________________________

4.3.20 Mechanical Assy

1) Remove the Main Rear and Front Covers (refer to chapter 4.3.4 and 4.3.5).

2) Unscrew the screws securing the ground strips on the lower shield on both sides of the

printer.

3) Unplug all the connector from the main board.

4) Unscrew the two screws retaining the mechanical block to the base assy.

5) Cut the two plastic self-locked strips retaining the mechanical blocks on the base assy

and remove the mechanical assy.

6) Pay attention to the paper position mylar on the base assy.

Replace the mechanical assy following the above instructions in reverse order.

Figure 4.20 Mechanical Assy

____________________________________________________________________________________________

LA400 Multiprinter 4. 24 ER-LA400-SV

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 126 127

Žádné komentáře

Digital LA400 Servisní příručka Strana 76